Loop slide show

Set the investor deck to loop during the booth demo: have the slideshow start automatically on launch, loop continuously until ESC is pressed, and make sure animations and embedded video restart properly each loop. Test the full 12-slide run twice and confirm it cycles smoothly; I need confirmation by Tuesday 9 a.m.

Before I hand this to events, make the looping booth presentation behave like a polished demo: enable automatic start and continuous loop, ensure any embedded videos either restart at loop start or are set to play only once with a still frame, and remove any timers or mouse-dependent triggers. Flag slides that rely on clicks that will break in loop mode.

We’re putting the deck on a booth laptop to run continuously but three product slides have ‘on click’ animations and a demo video that needs a restart. The events lead and product manager won’t be there to click. What’s the minimal set of changes to make the deck loop reliably and still show the product animations as intended?

Every trade show I spend last-minute hours fixing decks that were supposed to run unattended: animations don’t trigger, videos don’t restart, and the loop breaks. I lose credibility with events and waste staff time. What standard setup and pre-flight checks should I adopt so a deck reliably loops in a kiosk for days without tinkering?